Canada · Batch brewing
How much coffee should go in the carafe?
Measure the water going into your drip brewer, then use a real pot of coffee to work out how many mugs it serves.

How much ground coffee do I need for a litre of water?
Start with 60 g of coffee for 1 L of water going into the brewer. That gives 30 g for 500 mL, 45 g for 750 mL and 75 g for 1.25 L. The brewed amount in the carafe will be smaller because the wet grounds and filter retain water.
Size the morning pot by the mugs on the table
Fill a cottage mug to a comfortable drinking line and measure the water. Four 250 mL mugs need 1 L of finished coffee. Run one batch and measure what reaches the carafe. If it delivers only 900 mL, split the next brew into two smaller batches if your brewer cannot take more water.
Read the marks on your own brewer
A machine’s cup line can be much smaller than the mug you take to the breakfast table. In Café Barista’s Moccamaster chart, the eight-cup mark is 1 L of input water. Measure the fill level you actually want in a favourite mug. A mug holding 250 mL to that level needs a different plan from an eight-cup machine label.
Use your brewer’s instructions for its minimum batch, maximum fill, filter shape and any half-pot setting. If the number of guests takes you beyond the machine or basket limit, brew a second batch.
Brew and measure one reference pot
- Measure 750 mL of fresh water and weigh 45 g of beans, or scale both quantities to your machine. Grind for drip coffee, fit the correct filter and spread the grounds evenly in it.
- Run the brew cycle with the carafe in place and wait for the basket to finish draining. Swirl the carafe gently to mix the earlier and later coffee before pouring.
- Measure how much brewed coffee you actually collected. Use the carafe’s millilitre marks or tare a heat-safe vessel on a suitable scale and weigh the drink. Record the result alongside the input amount and grinder setting.
Work back from the mugs on the table
Suppose your 750 mL test produced about 660 mL in the carafe. Three mugs filled to 240 mL need 720 mL of brewed coffee. Scale both ingredients by 720 ÷ 660. The next pot would start with about 820 mL water and 49 g coffee. This is an estimate drawn from your own test. Check the finished amount again when you change batch size.
If the servings are right but the taste is too strong, test a little hot water in one mug. If you like the result, adjust the coffee dose slightly the next time you make that batch. That lets you compare one recipe change at a time.
Common questions
Does the recipe use a litre of water or a litre of finished coffee?
It uses a litre of water added before brewing. To serve a litre of finished coffee, use a measured test batch to allow for the water left in the grounds.
Can I use my roaster’s 1:16 recipe instead?
Yes. Divide the input water weight by 16. For 800 g of water that gives 50 g of coffee. Keep the same way of measuring when you compare that recipe with 60 g per litre.
